Device FAQs
1. Put the cabinet bottom on a steady and even surface.

2. Insert the side panel into the cabinet bottom. May need to press the buttons while inserting.

3. Put the bottom connecting wires through the pillar and make sure the end of wires comes out from top of the pillar.

4. Align the pillar with the arrow marking at the bottom. Then insert the pillar into the cabinet bottom. DO NOT turn the pillar.

5. Connect the top connecting wires and the bottom connecting wires, turn to lock. You may put the end of the top cabinet without connecting wire on bottom cabinet for easy installation. Ensure the colors are matched.

6. Insert the cabinet top to the side panel. May need to press the buttons while inserting.

7. Attach the cabinet top to the pillar.

8. Turn the pillar to lock it in place.

9. Assembly finished. Continue with Setup below.

Setup Guide: Assemble aspara Nature+ Smart Grower
1. Connect the power cord to the power adaptor. Plug into aspara first then the power outlet.

2. Insert the sensing probe into the water tank.

3. Fill the tank to ‘max’ mark with tap water (if the tap water in your area is hard water, use distilled water).

4. Add 1 pack of nutrients into water in the tank. The nutrient packs can be found inside aspara seed kit.

5. Insert the tank into the cabinet on the stand (the front part of the tank should be inline with the stand). Use both hands when insert. The light will be on and the control panel will show 'Water tank connected' when properly inserted.

5a. For aspara Nature+, make sure the tank lock (Red circle) comes out after tank inserted. (And you will need to press the tank release button (arrow) to release the tank after locked.)

6. Insert seed capsules according to seed kit setup.

7. Place a germination dome over each seed capsules to keep seeds moist during germination.

8. Cover all capsules with the germination domes. You will need to remove them when you see sprouts growing in a few days or a week time (with 2 leaves appear or 1cm high).

9. Cover any empty holes with a grow hole cover.

10. Make sure all holes are covered to avoid bugs.

11. Slide the grow tray into the cabinet and push the grow tray in firmly. When properly inserted, the light will be on and the control panel will show 'Grow tray connected'.

12. Press any button to start planting online or offline. See How to connect for connection details.

13. Add more water after water running finished to make sure your grower is fully filled with water.

Setup Guide: How to set up the smart grower



Select ‘Harvest’ in control panel.

When you have planted over 60 days, we would recommend to replace all water in tank and grow tray with fresh water.
Please visit our blog for more details.
You can shift from offline to online mode only after planting program ended. See How to Connect to go online.
When going from online to offline mode, pin the “Reset” button and make your choice again. If you reset during planting mode, you will not be able to continue with your current planting data.

The appliance should be cleaned with hands and aspara cleaning function between each growing session or if it has not been used for a while. Make sure planting program is ended (finish planting) before cleaning.
Please visit our blog for more details.

Salad vegetables (e.g. kale, rocket): 8 capsules
Herbs: 12-16 capsules
Tomatoes: 4 capsules
Radishes: 8-12 capsules
Flowers: 12-16 capsules
aspara smart grower operates within a range of 100-240V (50-60Hz).
Please contact your nearest authorised service centre or email us at info@aspara.hk
If you cannot find your answer above or you need our support, seek help from our Customer Support.